Stanley Fat max Instruction Manual page 4

• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to the state of California to cause
WARNING:
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
and other construction activities. Wear protective clothing and wash exposed
skin may promote absorption of harmful chemicals.
cause serious and permanent respiratory or other injury. Always use NOSH/OSHA
WARNING:
Use of this tool can generate and/or disperse dust, which may
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Wear appropriate hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
120V
Volts
240V
More
Ampere Rating
Than
0
6
10
12
• The label on your tool may include the following symbols. The symbols and their
Symbols
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
sfpm ............surface feet per minute
Minimum Gage for Cord Sets
0-25
Total Length of Cord in Feet
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
- 6 18
- 10 18
- 12 16
- 16 14
26-50 51-100
51-100 101-200
American Wire Gage
16 16
16 14
16 14
12 Not Recommended
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
4
101-150
201-300
14
12
12
reciprocation per minute