Section 5: Major Components; Figure 10: Major Component Descriptions - HeatRite VM-80 Installation, Operation & Service Manual

VM-S I , O
ERIES NSTALLATION PERATION AND

SECTION 5: MAJOR COMPONENTS

FIGURE 10: Major Component Descriptions

Burner with Tube Gasket
Must be installed with the
Burner Tube
Supplied in 10
'
(3 m) lengths. Burner
tube is always the first tube
after the burner.
Tube and Reflector Hanger,
Wide Pattern with Clamp
Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
Tube and Reflector Hanger,
Wide Pattern
Suspend system from these
hangers.
Reflector Support Strap,
Wide Pattern & Wire Form
Flex Gas Line with
Shut Off Cock
10 of 71
S M
ERVICE ANUAL
flame observation
window facing down.
Reflector
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and
on Page 15, Figure 13.
Minimum overlap is 6" (16 cm).
Tube
Heat treated
aluminized tube supplied
in 10' (3 m) lengths.
Vent Adapter
Turbulator must
be installed in the last
standard section of tube.
Turbulator is not required on the
VM-200. For installation see
Page 18, Section 6.4.
Coupling Assembly
with Lock
Reflector End Cap
Punch out center
section to
accommodate tube.
Turbulator