Parts Included:
Series 3 Hopper Assembly
Mounting hardware
Tools Required:
Phillips & Standard Screwdrivers
Installation:
Step 1 Protecting the Igniter :
•
Carefully remove the tape holding the igniter to the rear
panel of the hopper. Diagram A
•
Place Igniter inside the hopper, through the large air opening.
This allows for easy installation of the hopper to the barrel, as
well as protects the igniter from damage. Diagram B
Step 2 Attaching the hopper to the barrel:
•
Carefully lift the entire hopper to the left hand
side of the main barrel.
•
The mounting bracket on the rear of the hopper (D ) must be raised
slightly higher then the receiving bracket on the barrel.(C)
Diagram C & D
•
Push the top of the hopper tightly against the main barrel, while
keeping the bottom away. This stops the auger feed from
scratching the powder coat.
•
Next holding the hopper fairly level, press downward to clip the
hopper lip (D) onto the mounting bracket. (C)
Then the bottom should fit tight against the barrel.
•
Using your 1/4" nut driver, electric drill and
4 of the #10 x 16 x 1/2" dritap screws
secure hopper to barrel through the holes provided.
Diagram E
NOTE: If the holes do not line up, the hopper may need to
be fully clipped into place.
..... Con't
Assembly Instruction
INSTALLING THE HOPPER & IGNITER
1/4" Hex Nut Driver &
5/16" Hex Nut Driver
Diagram C
A
B
C
D
E