Heat & Glo Curve 100 Owner's Manual
Curve 100 wood stove owner's manual
Hide thumbs
Also See for Curve 100:
- Owner's manual (20 pages) ,
- Owner's manual (21 pages) ,
- Owner's manual (20 pages)
Subscribe to Our Youtube Channel
Related Manuals for Heat & Glo Curve 100
Summary of Contents for Heat & Glo Curve 100
-
Page 1: Wood Stove
CURVE 100 Wood Stove Australian Owner’s Manual Installation and Operation 7/11/2014 Heat & Glo • 7076-250C... - Page 2 Ceiling Plate may vary in size depending on ceiling angle. Please specify ceiling pitch prior to ordering the • ceiling plate. Heat & Glo Curve 100 wood burner’s are tested and approved to the N.Z. National Environmental Stan- • dards;...
-
Page 3: Table Of Contents
Curve 100 Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. WARNING! Indicates a hazardous situation which, if not avoided may result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury. -
Page 4: Technical Data
Max. wood length: 25 cm installation and fi tting and also responsible for observing the Weight Curve 100: ca. 98 kg fi tting and operating instructions detailed in this manual. Weight heat-accumulating stones: ca. -
Page 5: Installation & Assembly
Curve 100 Installation & Assembly the back panel so the fl ue attachment ring can slip through A. Positioning Your Wood Burning Stove The wood burning stove must be set up so the stove, fl ue it. Attach the back panel back onto the appliance using connection, fl... -
Page 6: Leveling The Unit
F. Distance to Furniture: 1000 mm But please check to avoid furniture or other furnishings being dried out due to being too close to the stove. G. Distance to Flammable Walls Curve 100 and 300 SINTEF evaluation of safety distances Combustible wall Brick wall... -
Page 7: Dimensions & Clearances
Curve 100 Dimensions & Clearances A. Appliance Dimensions 7/11/2014 Heat & Glo • 7076-250C... -
Page 8: Floor Protector
▪ If installed directly onto a concrete slab, the concrete slab B. Floor Protector can be considered as the fl oor protector,but must maintain Heat & Glo Curve 100 does not require a insulating Floor the minimum measurement listed. Protector, as they are tested and comply with the minimum Floor Protector requirements of AS/NZS 2918:2001. - Page 9 Curve 100 FLOOR PROTECTOR Fig. 9.1 CORNER POSITIONING (45°) Table 2 DESCRIPTION With Double Pioneer Double Flue Mounted Shield Universal Flue Shield Shall be Fitted Fitted Min. clearance from fi rebox corner to corner walls Min. distance from center of spigot to corner walls Min.
-
Page 10: Operation
D. Fuels The Curve 100 Wood Stove is designed and tested for The Curve 100 wood stove is designed to burn a wide intermittent use. This means that it is not designed for or range of fi rewood species. In general hardwoods are better recommended to burn continuously for 24 hours. - Page 11 Curve 100 Lower intake holes Add paper to back repot making sure to not block lower air inlet with paper Add small pieces of wood on top of paper allowing for w between pieces Secondary Holes Add larger log on top of pile making sure it does not go above the upper intake holes Fig.
-
Page 12: Primary Air
Curve 100 E. Primary Air G. Secondary Air This unit is equipped with a secondary combustion system (Lower Air Control) (Fig. 12.1) The primary air is controlled by the lever on the left side of that cannot be regulated. The purpose of this secondary the appliance. -
Page 13: Side Door Handle Operation
Curve 100 this material is a high quality material specifi cally designed I. Side Door Handle Operation for wood burning appliances, it is subject to normal wear (Fig. 13.1) and tear and should be replaced if burn times are reduced To open the front door, pull the lever located on the blower or there is concern of leakage. -
Page 14: Chimney Systems
Curve 100 Chimney Systems A. Chimney Systems 1. Either locate the appliance in position or by measuring at A chimney or fl ue system is required to run your wood the ceiling mark the fl ue pipe centre position. Check that stove safely and effi... - Page 15 Curve 100 Recommended Location: Recommended Location: • Above peak • Above peak • Inside heated space Marginal Location: • Wind loading possible Marginal Location: • Below peak Location NOT recommended: • Not the highest point of the roof • Wind loading possible Location NOT recommended: •...
- Page 16 Outer Casing Inner Casing Internal Swage 12.5 V ented Ceiling Plate Pioneer Double Flue Shield Flue Pipe Heat & Glo Curve 100 Floor Protector Fig. 16.1 FLUE PENETRATION 3000 More than 3000 or less 3000 600 min. 3000...
-
Page 17: Maintenance
Curve 100 Maintenance A. Ash Drawer B. Refractory The fi rebox is lined with molded refractory fi rebrick. The (Figure 17.1) refractory protects the outside of the appliance and retains Before attempting any maintenance on the unit ensure the heat necessary for a clean effi cient burn. The material that the unit is cold and has no embers in the fi... -
Page 18: Troubleshooting
Curve 100 Troubleshooting • Wood pieces too large on lighting Smoke escaping • Damp wood • Inferior fi rewood (waste wood, pallets etc.) • Chimney not drawing properly • Chimney not drawing suffi ciently • Chimney is not properly dimensioned for the stove •... -
Page 19: Warranty
Curve 100 Warranty AUSTRALIAN WARRANTY INFORMATION Hearth & Home Technologies Inc (HHT) 1445 N. Highway | Colville, WA 99114 | (509-684-3745) HHT extends the following manufacturer’s warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. - Page 20 Curve 100 OTHER RIGHTS The HHT manufacturer’s warranty is in addition to other rights and remedies that you may have under Australian law. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
-
Page 21: Service Parts List
Curve 100 Service Parts List CURVE-100G-HS Service Parts Beginning Manufacturing Date: June 2013 Wood Stove Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. - Page 22 Curve 100 CURVE-100S-HS Service Parts Beginning Manufacturing Date: June 2013 Wood Stove Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
-
Page 23: Reference Materials
Curve 100 Reference Materials A. AS/NZS 2918:2001 General Notes WARNINGS: WARNING: THE APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED IN ACCORDANCE WITH AS/NZS 2918 AND THE APPROPRIATE REQUIREMENTS OF THE RELEVANT BUILDING CODE OR CODES. WARNING: APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD SHALL COMPLY WITH THE REQUIREMENTS OF AS/NZS 4013 WHERE REQUIRED BY THE REGULA- TORY AUTHORITY, I.E. - Page 24 CONTACT INFORMATION: Hearth & Home Technologies 1445 North Highway Colville, WA 99114 Division of HNI INDUSTRIES We recommend that you record the following pertinent information for your Curve 100 Date purchased/installed: Serial Number: Location on appliance: Dealership purchased from: Dealer phone:...
Need help?
Do you have a question about the Curve 100 and is the answer not in the manual?
Questions and answers