Hub-14 Installation Summary - HP J2415A Installation And Reference Manual

Hub-14 Installation Summary

The remainder of this chapter describes the installation procedures for the
Hub-14. A summary of the procedures is provided below:
1. If required, install any optional accessories.
2. Verify that the hub works correctly.
3. Mount the hub in a rack, on a wall, or on a tabletop.
4. Connect the hub to the network. This includes:
• LAN downlink port connections to network end nodes, such as
computers or other supported devices
• Cascade connections to other 100VG hubs
• Connections to other networks, such as a 10 Mbit/s Ethernet/IEEE
802.3 network (requires an HP 100VG SNMP/Bridge Module)
5. If appropriate, connect a management console (Windows-based PC) to
the hub or chain of hubs (only one hub in a chain needs to have a console
connected). Run HP Stack Manager or HP Interconnect Manager on the
management console to configure and manage the hub (refer to chapter
2, "Installing and Using HP Stack Manager," for more information).
Installing the HP AdvanceStack Hub
1-3