Install Optional Accessories - HP J2415A Installation And Reference Manual

1. Install Optional Accessories

You will typically install optional modules (as described on the previous
page) into the hub before mounting the hub in a rack or other location,
especially if access to the hub's accessory slots will be impaired.
To install any of these optional accessories, refer to the documentation
supplied with the accessory products. Never try to separate the two boards
that are connected together to form the HP 100VG SNMP/Bridge Module. If
you want remote access server or router capability, you need to order those
capabilities as separate products and install them into another 100VG hub.
Contact your HP-authorized dealer or reseller for information.
W a r n i n g
Before installing a module into the 100VG expansion slot, unplug
the hub. Electrical shock or other injury can result if you
attempt to install the module without unplugging the hub.
If you do not install an optional module, verify that the cover
plates are covering the 100VG Expansion Slot and the two
transceiver slots on the front of the hub. Cover plates are required
not only for safety, but also to ensure proper hub cooling.
HP J2414B 100VG/ET SNMP/Bridge Module
Transceiver Slots: The two slots in the front of the hub accept the
following transceivers:
•
HP J3027A 100VG Fiber-Optic Multimode ST Transceiver Module
•
HP J3030A 100VG Twisted-Pair Transceiver Module
Installing the HP AdvanceStack Hub
1-5