Face Plate Timer Features - Kenmore SEARS 625.34846 Owner's Manual

Kenmore water system user manual
Table of Contents

Advertisement

SECTION 2
.owYOUR WATER
SO E.ER WORKS
I
2A.
FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes,
a manually started regeneration
(recharge) may be desired, or needed. Two
examples are...
...You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.
...You did not refillthe softener with salt before it
was gone.
You can start a regeneration right away, or you
can set the timer to regenerate at the next 2:00
AM (or other preset recharge time).
Do the
following.
RECHARGE NOW
• Press the ON/OFF-HOLD
button and hold
for 3 seconds. The softener
enters the fill cycle of regen-,
eration right away...the
dis- _'
# m__0
play shows "Filling
NOW". r!
i !
Th s regeneration will last for
about 40 minutes. Then, you
will have soft water again.
RECHARGE TONIGHT
• Press and release (DO NOT HOLD) the
ON/OFF-HOLD
button. RE-_=_
CHARGE TONIGHT flashes
in the display, and the soften-
er begins regeneration at the
next preset recharge time. Press and release
the ON/OFF-HOLD button once more if you
decide to cancel the regeneration, and RE-
CHARGE TONIGHT.
PROGRAM MEMORY
If electrical power to the softener goes off, the
time display is blank but the face plate timer
keeps the correct time for about 6 hours. When
electrical power comas on again, you have to
reset the present time only if the display is
flashing. The HARDNESS
and RECHARGE
TIME never require resetting unless a change is
desired.
Even if the timer is incorrect after a long power
outage, the softener works as it should to keep
you water soft. However, regenerations may
occur at the wrong time of day untilyou reset the
timer to the correct time of day.
ERROR CODE
An error code could appear in the face plate
display if a problem occurs in the softener
electronics. If you see an error
code instead of the present time
IEI'I"
0
of day, please call you local
Sears Service Department for
service.
SOFTENER STATUS DISPLAY
1. SERVICE ( PROVIDING SOFT r
WATER) POSITION: The display|"
]
shows the present time of day. IfJ
_:1._ M
_--
I
"TURBINE" is gashing,soft water
iscurrentlyin use.
2. RECHARGE POSmONS:
A. Fill Cycle- Filling NOW shows
"--'
I
in the display.If softwater is being F!
/ I i ,_g
I
used,_'URBINE" gashes.
B. BRINING, BACKWASH AND
FAST RINSE CYCLES - The dis-
playshewsthe minutesof recharge
,,.=p= ,,,,..,
remainingbeforeretum to soft wa-
I_" J_:U_
ter service. RECHARGE NOW is _
tow
also gashing.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micromax 625.348460

Table of Contents