Asko DW70 Service Manual page 23

PROGRAMS AND CONTROl UNIT
DW70.5
Panel type DW70.5, L = LED, S = Push button,
D = Display
Variant settings
When the main power switch is switched on for the
first time after replacing the control unit, the variant
settings menu is displayed.
1. Press the Program button (S1) until the
desired variant is selected:
The display shows the number 1 and L1
flashes:
Variant 1 = Time saver
The display shows the number 2 and L2
flashes:
Variant 2 = with Super rinse
The display shows the number 3 and L3
flashes:
Variant 3 = with Tab
The display shows the number 4 and L4 flashes:
Variant 4 = with Time program
2. Confirm your selection by pressing Start
(S2). The machine detects the presence of
a turbidity sensor, a pressure sensor and a
spray arm diverter. The program returns to
the main menu.
To return to the variant settings menu:
1. Turn off the main power switch (I/0)
2. Wait at least 5 seconds
3. Press and hold the Program and Start but-
tons (S1 and S2)
4. Switch on the main power switch (I/0)
5. Release the Program and Start buttons (S1
and S2). It takes a few seconds for the ma-
chine to detect that S1 and S2 are pressed.
Proceed to step 6 within five seconds
6. Press Start (S2) three times in quick suc-
cession. L1, L2, L3 or L4 flashes on the
display depending on the previous setting.
7. Use the Program button (S1) to select a vari-
ant
8. Confirm with the Start button (S2). The
program automatically returns to the main
menu.
Water hardness setting
Activating the settings menu:
1. Turn off the machine using the main power switch.
2. Press and hold START/STOP and Drying selector at the
same time as you press the main power switch once. You
have now activated the Softener setting menu.
START
+
+
STOP
3. Use the Program button to adjust the water hardness.
PROG
4. Press START/STOP to save the setting and exit the
menu.
START
STOP
Total reset
Setting Water hardness [°dh]
Display shows 0 0-5 (incl. machines without
water softener)
Display shows: 1 6-8
Display shows: 2 9-11
Display shows: 3 12-14
Display shows: 4 15-19
Display shows: 5 20-24
Display shows: 6 25-29
Display shows: 7 30-39
Display shows: 8 40-49
Display shows: 9 50+
To reset the machine to its factory settings.
1. Turn off the main power switch (I/0)
2. Wait at least 5 seconds
3. Press and hold the Program button (S1)
4. Switch on the main power switch (I/0)
5. Release the Program button (S1).
The machine will reset various settings, although
not water hardness, language, variant and intake
volume. The machine detects the presence of a
turbidity sensor, a pressure sensor, a humidity
sensor and a spray arm diverter. The machine
then automatically returns to the main menu.
23