DeWalt DWD450 Instruction Manual page 8

FIG. 3
I
FORWARD
SLIP CLUTCH
The DWD450 and DWD460 are each equipped with a slip clutch.
The clutch is active when the low speed (1) is selected. When the bit
or cutter bites into the workpiece, the clutch will slip and a ratcheting
sound will be heard. Release the trigger. Continued clutching of the
tool will reduce the life of this feature.
E-CLUTCH TM (DWD460)
The DWD460 is equipped with E-Clutch
motion of the tool and reduces the motor torque to a manageable
level if necessary. The E-Clutch TM
status.
INDICATOR DIAGNOSIS
Tool is functioning
OFF
normally
E-Clutch TM has been
SOLID
activated (ENGAGED)
I
REVERSE
TM . This feature senses the
indicator (G) will illuminate to indicate
SOLUTION
Follow all warnings and
instructions when
operating the tool.
With the tool properly
supported, release trigger.
The tool will function
normally when the trigger
is depressed again and the
indicator light will go out
INDICATOR DIAGNOSIS
E-Clutch TM is
FLASHING malfunctioning
(SERVICE)
NOTE: If tool power is insufficient for normal drilling and LED does not
flash take tool to authorized D WALT repair center.
E
Bail Handle (Fig. 4)
A bail handle is provided for carrying the tool and for use as an
additional handle. Assemble the bail handle in one of the positions
shown in Figure 4. When changing the location of the bail handle from
one position to the other, completely remove the two bail handle bolts
(E) securing it. Flip the handle over and reinstall.
FIG. 4
J
Side Handle (Fig. 5)
WARNING: To reduce the risk of personal injury, always operate
the tool with the side handle properly installed and tightened. Failure
to do so may result in the side handle slipping during tool operation
and subsequent loss of control. Hold tool with both hands to
maximize control.
6
SOLUTION
Take the tool to an
authorized D WALT
E
repair agent.
E