Table of Contents
Advertisement
SECTION 4
I
STEP BY STEP GUIDES
TO INSTALL
4D.
CONNECT
DRAIN HOSES
IF INSTALLING A CLARIFIER, NEUTRALIZER OR TASTE
& ODOR FILTER, SKIP PAGE 15 AND GO TO PAGE 16.
2.
CONNECT THE BOTTLE DRAIN TUBING
AUTOMATIC IRON FILTER
Connect a length of 5/16" plastic tubing to the vent fitting
on the feeder valve (Figure 11) using a nut ferrule. Put the
other end of the tubing over the drain and fasten it to the
valve drain hose so it stays over the drain. If a copper
drain is needed, get the tubing and fittings shown it Fig-
ure 11.
WARNING:
THIS DRAIN (VENT) MUST ALWAYS BE OPEN TO AL-
LOW AIR TO ENTER AND LEAVE THE BOTTLE. IF
PLUGGED, THE BOTTLE WILL COLLAPSE.
IF THE
BOTTLE OVER FILLS, SOME POTASSIUM PERMAN-
GANATE SOLUTION
COULD
COME FROM
FROM
THE DRAIN TUBING. BE SURETHE END OFTHETUB-
ING IS ALWAYS OVER THE DRAIN.
BOTTLE DRAIN TUBING,
AUTOMATIC
IRON FILTER
_
1
d_.
_5/16" O.D. Tubing
_1 IIII I1_ _
straight
_1 IIII I_d_----
connector
COPPER
BOTTLE DRAIN
1/4" Copper (Hard
or Soft) Tubing
To Drain
Point
i
Compression
Adaptor
15
Advertisement
Table of Contents
