Provisioning The Phone; For Internal Use; For External Use - Fortinet FortiFone FON-260i Quick Start Manual

Provisioning the Phone

For instructions on programming your FortiVoice phone system for the phone,
refer to "Adding IP Phones" in Chapter 2 of the

For internal use

The phone supports 'plug and play' installation employing the automated
provisioning process for discovering FortiVoice phone systems.
After discovering the FortiVoice system on the LAN, the phone downloads
the configuration and registers with FortiVoice. If the extension was
pre-configured via the FortiVoice management software, then the phone
display should show the extension number and name. If not yet configured
in the FortiVoice system, then the MAC address of the phone will be visible
as a choice in the MAC select list for that model of phone in the Local
Extensions section of the configuration.

For external use

When connecting your IP phone at a remote location for external use,
perform the following steps:
1. Preconfigure the extension in the FortiVoice management software.
2. Power up the phone and press the
Settings.
3. Select 6. Firmware Update and press the OK button.
4. From the Firmware Update menu, select 2. TFTP Server Address.
5. Enter the Public IP address or FQDN of your FortiVoice system. Press
the OK button.
6. Press the
OK button to reboot the phone.
If the phone still says "Not Registered" after 30 seconds, see
"Troubleshooting" on page
If you encounter problems, ensure the appropriate ports are forwarded
from the firewall to the FortiVoice system. For more information, see the
FortiVoice User
Installation
button to exit the configuration then press the
10.
Guide.
5
FortiVoice User
button, then select 3. Phone
FortiFone™ QuickStart Guide
Guide.