Table of Contents
Advertisement
G
CM35
Specify whether the ISDN trunk is released
when the system receives ISDN DISCON-
NECT message with Progress Description=08
from ISDN (effective for an outgoing call).
[Series 3200 R6.2 software required]
NOTE:
When sending the in-band tone to
the calling station from ISDN, set
the second data to 1.
In this case, the ISDN trunk will be
released automatically in 30 sec-
onds after the calling station re-
ceives the in-band tone or when the
calling station goes on-hook.
Specify whether the ISDN trunk is released
when the system receives ISDN DISCON-
NECT message with Progress Description=08
from ISDN (effective for an incoming call).
[Series 3200 R6.2 software required]
NOTE:
When sending the in-band tone to
the called station from ISDN, set the
second data to 0.
In this case, the ISDN trunk will be
released automatically in 30 sec-
onds after the called station receives
the in-band tone or when the called
station goes on-hook.
Specify whether the ISDN trunk tone is sent
when the ISDN trunk is seized.
[Series 3400 software required]
H
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=158
(1)
00-63: B channel Trunk Route No.
(2)
0 : To release
1 : Not released
•
Y=208
(1)
00-63: B channel Trunk Route No.
(2)
0 : Not released
1 : To release
•
Y=200
(1)
00-63: B channel Trunk Route No.
(2)
0 : To send
1 : Not sent
– 96 –
ISDN-PRI PROGRAMMING
DATA
NWA-008852-001 Rev.5.0
98ch3001.fm
NOVEMBER/15/2006
Advertisement
Table of Contents
