Advertisement
Electrical
Shock Hazard
l
Disconnect
electrical
power
at the service panel (fuse box
or circuit
box).
l
Make sure that the water
supply
line, drain line and
wiring
do not touch any
exposed
terminals
of the
dishwasher
wiring.
Failure to do so could result in
serious
injury or death.
Cut a 1 -inch hole in the
cabinet for the electrical
wiring to pass through. If this hole is
cut in a wood cabinet, the hole
should be sanded until smooth. If
the hole is cut in a metal cabinet,
the hole must be covered by $I
grommet (Part No. 302797).
Run
flexible cable from fused disconnect,
circuit breaker or junction box
through hole in cabinet. Cable
should extend 24" from back wall.
Remove the 2 screws below
the access panel. Pull
bottom of panel out and lifl up and
away from dishwasher.
Set access
panel aside on a protective covering.
13.
Numbers
correspond
to steps.
8.
18.
Floor Damage
Slide dishwasher
onto
cardboard
or hardboard
before moving
across floor.
Failure to do so may cause
damage to floor covering.
w
w
The
diz'
'
'
'
'
The dishwasher is shipped
I to be ir
to be installed in a 34"
cabinet opening. Mea:
cabinet opening. Measure height of
cabinet opening from I
cabinet opening from underside of
countertop to floor. Ad
countertop to floor. Adjust leveling
legs to required openir
legs to required opening height.
Place drain hose on the left
side of the cabinet opening
between the motor and the frame.
Latch dishwasher
door. Grasp
dishwasher
by the door frame and
push the dishwasher
into the cabinet
opening. Be careful not to oush on
the dishwasher
panels. Ce'nter
dishwasher
in cabinet opening.
Check that front leveling legs are
firmly against the floor.
Page 5
Advertisement
