Base Station - Sanyo CLT-538 Service Manual

TEST MODE
i
BASE STATION
1. Overview
By operating the Slide SW and Keyboard SW on the BASE UNIT, the pass or fail of the completion
process can be determined through the status of the LEDs, the sound of the key monitor, etc.
2. Startup.
( 1 )
Startup of the TEST MODE by operation of the SPEAKER key. (RX POWER ON, CHARGE/lN USE LED ON)
o Turns on by pressing the SPEAKER key at power on.
@ Continue pressing the SPEAKER key and set the TONE/PULSE SW from PULSE to TONE.
@ Release SPEAKER key.
INITIAL CHANNEL = IOCH , VCO adjustment channel
When the TEST MODE begins, a beep is heard.
( 2 ) In case of TEST MODE in this way, there are several ways to change the normal mode.
@ detect charge
@ turn off the power, and turn on the power
3. VCO ADJUSTMENT
mode/TX ADJUSTMENT mode/RX ADJUSTMENT mode
( 1 ) adjustment channel.
@ VCO ADJUSTMENT CHANNEL: 10CH (TEST MODE startup)
@ TX ADJUSTMENT CHANNEL: 7CH ( * key on)
@ RX ADJUSTMENT CHANNEL: 6CH (FLASH key on)
( 2 ) Setting of PLL channel.
@ Press two numeric keys (1 -10: channel No.).
For example) 1CH -+ O and 1key
[
@ Increment of PLL channel. -D Press the PAGE key at the TEST MODE
1
(This item not use.)
(TX and RX are the same number of channel.)
l-2-3~———~2252b-b l-2-D3~———
( 3 ) TX POWER control (By operating the TONE/PULSE SW)
TONE/PULSE SW PULSE + TX POWER ON, TONE/PULSE SW TONE ~ OFF
( 4 ) TX DATA is ON. (Continue pressing the REDIAL/P key)(TX MUTE ON)
NOTE: Only REMOTE TALK MODE and INTERCOM MODE.
( 5 ) RX MUTE control (By operating the RING SW).
RING SW ON + RX MUTE ON, RING SW OFF ~ RX MUTE OFF
4. Call circuit inspection mode
( 1 )
how to setting (2 way)
@ #keyandl-5 key
@ By pressing the SPEAKER key, the mode is changed.
MODE1 : REMOTE TALK MODE
REMOTE -~ LINE
MODE2: BASE TALK MODE
BASE +-~ LINE
MODE3: INTERCOM MODE
BASE +-~ REMOTE
MODE4: REMOTE H/F TALK MODE REMOTE H/F++ LINE
MODE5: CUTOFF MODE
5.
Detection circuit inspection mode
(CHARGE/lN USE LED ON)
(SPEAKER LED ON)
(CHARGE/lN USE LED& SPEAKER LED ON) '-
(SPEAKER LED ON)
(This item not use.)
(ALL LEDs ON)
( 1 ) Detection of ringer signal - CHARGE/lN USE LED is flashes, ringer sound output from speaker at the MODE3&5.
( 2 ) Detection of charge ~ When the charge is detected, the CHARGE LED lights.
In the case of the TEST MODE by operation of Power ON ~ When the charge is detected, the mode change to the normal
mode from the TEST MODE.
6. DTMF/PULSE send mode
( 1 )
DTMF OUTPUT MODE
Every time INT key press in MODE2, DTMF DIAL"1 ,2,30 0 0 "outPut.
( 2 ) DIAL PULSE OUTPUT MODE
o Every time REDIAL key press in MODE2, PULSE DIAL"1 ,2,3 " " o "output.
7. Key monitor inspection mode
" Every time the keys press, a buzzer sounds is output.
—
-11-