TABLE OF CONTENTS TABLE OF CONTENTS OVERVIEW DOGTRA TRAINING & BEEPER COLLAR FEATURES PACKAGE CONTENTS PRODUCT SAFETY AND HEALTH STATEMENTS TRANSMITTER & COLLAR PARTS OPERATING CHARGING THE BATTERY ACCUSTOMING THE DOG TO THE BEEPER SOUND MAINTENANCE WARRANTY AND REPAIR INFORMATION...
Locate mode it will beep as long as you press the Locate button. The tone of the The dogtra training/beeper collars are beeper can be selected with a toggle switch waterproof, lightweight and reliable. They are located on the transmitter. There are two built to withstand the most rugged conditions beeper modes : high and low.
Low and high tone beepers Dogs should be in good health during any e-collar Three beeper modes - Run & Point , training. Dogtra e-collars are not intended for use on Point and Locate dogs weighing less than 12 pounds or under 6 months of age.
TRANSMITTER purpose of behavior modification of dogs. They are not intended for human use or use on other animals. Dogtra Company does not assume any liability for improper use of the Dogtra e-collar. Aggressive dogs does not recommend using the e-collar to correct dogs that are aggressive towards other dogs or people.
COLLAR PARTS TRANSMITTER & COLLAR PARTS Transmitter Parts 1. Antenna COLLAR PARTS 2. Stimulation intensity selection dial Collar Parts 3. Toggle switch allows you to select between low and high tones.(On two-dog models, the toggle switch allows you to Beeper horn select between black and orange collars.) 4.
OPERATING OPERATING OPERATING THE To activate the beeper unit press the MODE button on the side of the transmitter. (Note : the ON/OFF button on the dog collar/receiver must be collar has three beeper activated for the beeper to operate.) modes along with constant and nick stimulation from the electric collar.
Page 8
OPERATING OPERATING To turn the beeper unit off, press the MODE INTENSITY SELECTION DIAL button a third time. The unit will emit three rapid beeps. The beeper unit is now off. The intensity selection dial is located on the top of the transmitter. Action of Number (1) one is the lowest level and number running...
OPERATING CHARGING THE BATTERY TWO DOG UNIT CHARGING THE BATTERIES two-dog unit Charging Cable operates just like the single- dog unit. The difference is in the transmitter where a toggle switch allows you to select either 120 volt Charger collar. The toggle switch is color-coded with black and orange to match the black and orange collar straps.
CHARGING THE BATTERY ACCUSTOMINGTHEDOGTOTHEBEEPERSOUND ACCUSTOMING THE DOG TO BATTERY CHARGING THE BEEPER SOUND When the batteries need recharging, the LED light will emit a rapid, double flash every 2 seconds. If the batteries have been allowed to Turn on the beeper collar and leave it outside run completely down, the indicator light may the dog’s kennel area for about a half-hour.
Typical Range purchased after Dec. 31, 2005. Fill out the warranty registration card that came with your Dogtra unit and mail it in along with a copy of Minimum Range your receipt within 30 days of purchase. Or, you can register your product online at www.dogtra.com.
Page 12
Dogtra DOES NOT replace defective units or (via regular ground service) back to the provide refunds after 30 days from date of purchase. customer is covered by Dogtra Co. within the continental United States. Any expedited Dogtra’s warranty DOES NOT cover repairs or shipping service will be at the owner’s expense.
Page 13
WARRANTY M E M O number. Or, you can visit our web site at www.dogtra.com to fill out a Service Request Form. If repair costs are not covered under warranty, we will call you for credit card information once the work has been completed.
Need help?
Do you have a question about the 2000T series and is the answer not in the manual?
Questions and answers