Advertisement
i
WARNING
Electrical
Shock and Personal
Injury Hazard
Disconnect
electrical
supply
before
servicing
or cleaning
the unit. Failure
to do so could
result
in electrical
shock
or
personal
injury from vacuum
cleaner
suddenly
starting.
TO REMOVE
BELT
Lay cleaner flat and flip cleaner to expose
nozzle base. To remove nozzle guard, slide
lock A to unlock position, to the left. Then
depress lock B to unlock nozzle guard°
Rotate/pivot the
nozzle guard and
pull off
I
Lift and remove
brushrolL Dispose
of old belt.
TO REPLACE
BELT
OR BRUSHROLL
Place new belt in area
of brushroll
without
bristleso
__
Place brushroll
shutoff pedal in
"Carpet"
position..
j__
Slide belt o ntomo to r
shaft. Ensure to loop
the belt around the
belt lifter shaft.
With new belt in place,
pull and slide brushroll
into nozzle making
sure that the brushroll
end caps are in the
correct orientation (see
diagram for end cap
orientation). Rotate
brushroll manually
to make sure belt is
properly aligned.
A
Secure by aligning
the three (3) tabs
in the base slots.
To reattach
nozzle
guard, rotate/pivot
back into position°
To secure nozzle
guard, push lock B
down to lock position.
Slide lock A into lock
position,
to the right.
13
Advertisement
