Vacuum - Kenmore 116.30912 User Manual

WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the uniL
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
ii ii ii iiiii i
TO REMOVE LIGHT BULB
Disconnect power cord from electrical out-
let.
Pry light lens
out at slot in
rear as shown
on both sides_
Rotate lens up
and lift off
Slots
m .....
F .'3 cAuT,o.
Do not use a bulb rated over 15Watt
(130Volt). During extended use, heat
from the bulb could overheat sur-
rounding plastic parts.
ii iii
Remove the !_[
light bulb by
pushingthe
bulb in while ToR
turning court- _
terclockwiseto
release from
the slot Then
pull the light
bulb straight
out
\\
To replace the
light bulb care-
fully insert and
turn clockwise
to securely fit
into slot.
Note: See PARTS AND FEATURES for bulb
number
" oo CAUTION
not plug in or turn on until the
vacvacuum is completely reassembled_
I iii H,I i IHI,I,
To replace light
tens, place tabs
at front of fens
into slots Rotate
lens down and
snap into place
To maintain efficient cleaning, the agitator
must be kept free of carpet pile, string, or
hair build-up After every 7 to 10 uses,
unplug and turn vacuum over and check
agitator for string and hair build-up
Use a scissors to remove any build-up
entangled around the agitator.
17