Kenmore 116.22822 Owner's Manual page 19

1. Remove Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
Push In
And TurA
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
3. To replace bulb,
"_-"_,Push In
push in and turn new
AndTun bulb clockwise. Bulb
must not be higher
k.._. than t5 Watts(130
_ Volts).
4. Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES
for the bulb number
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting,
TO CHECK BRUSHES
_ -.._.-_..____
when rushes
are worn to the
level of the base
support bars,
replace the
agitator.
Base Support Bats
TO REPLACE AGITATOR
ASSEMBLY
1. Remove Power-Mateq_'over,agitator
cover, belt and agitator assembly. See "To
Remove Belt" in BELT CHANGING AND
AGITATOR CLEANING.
2. Replace agitator assembly.
3. Reinstall belt, agitator assembly, agitator
cover and Power-Mate ® cover. See "To
replace belt" in BELT CHANGING AND
AGITATOR CLEANING.
19