Advertisement
ROOM ENVIRONMENTAL
CONTROLS
The installation may be fi tted with several additional environmental
controls.
A room thermostat may be fi tted in the room. This thermostat
controls the operation of the heater fan. Adjust the setting until a
comfortable environment is achieved.
Note however the higher the thermostat setting the higher the
running costs.
Where duct work is installed individual rooms will be fi tted with
supply air registers. If a room is not in use the supply registers
can be closed.
MAINTENANCE
A washable fi lter is fi tted to ensure the warm air distributed is clean
and free from dust. The fi lter is located in the detachable lower panel
and should be washed in warm soapy water at least twice a year
(see Fig. B). The fi lter panel can be removed by pulling the top end
away from the heater and lifting out the location hooks.
To maintain the appearance of the heater, wipe occasionally with
a dry cloth when the heater is cool. Do not use abrasive powders
or furniture polish.
IMPORTANT - Do not remove any panel before isolating the heating
unit from all electrical supplies. Additional maintenance should
only be carried out by a trained engineer or electrician. When
required contact your local electricity board or the installer. Regular
inspection should take place, at least every two years.
Advertisement
