INSTALLING
MACHINE
(Flat bed type)
1. Loosen the two hinge screws under
holes in the rear edge of the machine
bed.
2.
Raise hinge pins in the cabinet or
case. Slip machine head onto pins.
3. Tighten hinge screws securely.
4,
Push the speed control
plug onto
three-prong
connector
under
the
bed plate. Lower machine head to
front cabinet flap,
g
6,
Plug machine cord into any 110-120
volt wall outlet. Turn on power by
pushing light and power switch.
Spool pins are packed in accessory
box.
Screw
thread
spool
pins in
place securely with a screw driver.
Position
nylon discs as shown
in
illustration.
5