Troubleshooting Table - Poulan Pro ES35 Instruction Manual

For Parts Call K&T 606-678-9623 or 606-561-4983

TROUBLESHOOTING TABLE

WARNING:
Always stop unit and disconnect from the power source be-
fore performing all of the recommended remedies below except remedies
that require unit to be operating.
TROUBLE CAUSE
Chain does 1. Chain tension incorrect.
not move
when trigger 2. Guide bar rails pinched.
switch is 3. Trigger switch failure.
engaged
.
4. Circuit breaker tripped/
fuse failure.
Chain clat-
1. Chain tension incorrect.
ters or cuts
roughly.
2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly
sharpened, or depth
gauges too high.
5. Sprocket worn.
Chain stops 1. Chain cutter tops not
during cut. filed flat.
2. Guide bar burred or
bent; rails uneven.
Oil inade- 1. Oil tank empty.
quate for bar 2. Oil outlet clogged.
and chain
lubrication. 3. Guide bar oil hole
blocked.
Chain cuts 1. Cutters damaged on
at an angle. one side.
2. Chain dull on one side.
3. Guide bar bent or worn.
REMEDY
1. See "Check Chain Tension" in
Maintenance section.
2. Repair or replace.
3. Contact an authorized service
dealer.
4. Reset circuit breaker or replace
fuse.
1. See "Check Chain Tension" in
Maintenance Section.
2. Contact an authorized service
dealer.
3. Resharpen or replace chain.
4. See "Chain Sharpening" in
Service and Adjustments section.
5. Contact an authorized service
dealer.
1. See "Chain Sharpening" in
Service and Adjustments section.
2. Repair or replace guide bar.
1. Fill oil tank.
2. Contact an authorized service
dealer.
3. Remove bar and clean.
1. See "Chain Sharpening" in
Service and Adjustments section.
2. See "Chain Sharpening" in
Service and Adjustments section.
3. Replace guide bar.
15
www.mymowerparts.com