Troubleshooting Table; Declaration Of Conformity - Poulan Pro PN3816 Instruction Manual

TROUBLESHOOTING TABLE

WARNING:
Always stop unit and disconnect spark plug before performing all of
the recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not
1. Ignition switch off.
start or will run
2. Engine flooded.
only a few
seconds after
3. Fuel tank empty.
starting.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
1. Idle speed requires
Engine will
adjustment.
not idle
2. Carburetor requires
properly.
adjustment.
Engine will not 1. Air filter dirty.
accelerate, 2. Spark plug fouled.
lacks power, 3. Chain brake engaged.
or dies under 4. Carburetor requires
a load. adjustment.
Engine 1. Too much oil mixed with
smokes gasoline.
excessively.
1. Idle speed requires
Chain moves
adjustment.
at idle speed.
2. Clutch requires repair.

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy. Tel:
+39- -0341- -203211, declare that the chain saw models Poulan PN3816 and PN4218
CSI---AV from serial numbers 2008- -053(N or D) 00001 and onwards (the year is clearly
stated on the rating plate, followed by the serial number), comply with the requirements
of the COUNCIL'S DIRECTIVES:
of 22 June 1998 "relating to machinery" 98/37/EC, annex IIA;
of 3 May 1989 "relating to electromagnetic compatibility" 89/336/EEC, and applicable
supplements; and
of 8 May 2000 "relating to the noise emissions in the environment" in accordance with
Annex V of 2000/14/EC. The measured sound power is 108 dB(A), the guaranteed
sound power is 118 dB(A) and the net power is 1,6 kW or 1,7 kW.
The following standards have been applied: ISO 11681- - 1:2004, EN/ISO 12100- - 1:2003,
EN/ISO 12100- - 2:2003, and CISPR 12:2001.
Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3
S- -754 50 Uppsala, Sweden, has carried out EC type approval. The certificate(s) is
numbered: 404/02/901.
The supplied Chain Saw conforms with the sample that underwent the EC type approval.
08- -02- -22
REMEDY
1. Move ignition switch to ON.
2. See "Difficult Starting" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
Michael S. Bounds, Director
Product Safety and Standards
Handheld Consumer Products
15