ShuttleAssembly
ShuttleRace Cover
Shuttle
Shttle
Race
It may be necessary
to clean the shuttle
area occasionally.
L
Raise the needle bar to its highest
point and
remove
bobbin
case.
2.
Push levers sideways
of the shuttle
assembiy
and lift shuttle
and shuttlc
race cover out by the center pro.
3.
Clean the shuttle
race of any tint or small particles
of thread
with a small brush.
4.
Put a drop of oil on the center pin of the shuttle
and on shuttle
race (see arrows).
To reassemble,
hold shuttle
by center
pin and fit carefully
into assembly
opposite
the shuttle
driver.
Slip shuttle
race cover into place.
Snap the levers into position.
Occasionally,
remove
the needle plate and clean feed dog with a soft brush.
23