Button Sewing, Bar Tacking - Kenmore 1020 Owner's Manual

BUTTON SEWING
SETTINGS
Special Stitch Dial - Red Dot
Feed Dogs- Down
Zigzag Presser Foot
Use zigzag stitching plate.
1. Align two holes of button with slot
of presser foot and lower foot to
hold the button securely.
2. Turn hand wheel manually until
neeclle point is just above button.
3. Adjust stitch width control so
needle will enter left hole of the
button.
4. Turn hand wheel again by hand so
needle enters second hole. Re-
adjust stitch width if necessary.
Stitch a number of times.
5. Finish sewing with an extra two
inches of thread remaining. Draw
these threads to reverse side of
garment and tie.
M
w
!
I
I
m
!
!
!
!
!
I'
!
I
o!
BAR TACKING
SETTINGS
Special Stitch Dial - Red Dot
Stitch Width Control - 2 to 4
Stitch Length Control - Red Zone
Zigzag Presser Foot
Use zigzag stitching plate.
This stitch is similar to a very short
satin stitch and is used to reinforce
points of strain such as corners of
pockets and straps on lingerie.
Sew 4 to 6 zigzag stitches.
33