Siphon Cover; Electrical Connection - Beko WMA 767 W Installation & Operating Instructions And Washing Guidanse

Connecting to the water
drainage.
You may hang the drain hose at the
edge of a washbasin, sink or bathtub –
or attach it to a drain pipe permanently
(equipped with a siphon mechanism).
• Do not place the drain hose higher
than 100 cm above floor level for the
suds pump to be able to pump out.
Do not go below the minimal height of
40 cm, otherwise water will come out.
• Water should flow uninterruptedly.
Washbasins with a small drain are not
suitable.
• The end of the hose must not immerse
in the pumped-out water.
• Check with the customer service
for extension hoses. Do not use
homemade extensions with hose
clamps or alike!
• Use only the new hose supplied with
the machine, not an old existing one!
• Be sure that the hoses do not have
sharp bends.
Fastening the hose holder:
1. Pass the holder supplied during
delivery over the end of the hose.
2. Hold the drain hose with the holder
attached to it on top of the edge of
the washbasin or bathtub and fix it to
prevent slipping – e.g. fastening it by a
chain around the water tap.
Permanent connection to a

siphon cover.

A Qualified plumber should attach the
hose to prevent the hose from slipping
off. There is risk of overflow.

Electrical connection .

Connect the appliance to an earthed
outlet protected by a fuse of suitable
capacity.
Important:
• Connection should comply with
national regulations.
• Power cord plug must be within reach
after installation.
• The voltage and allowed fuse
protection is stated on the type label
plate.
• The stated voltage must match with
your mains voltage.
• Connection via extension cords or
multi-plugs is not allowed.
B A damaged power cable must be
replaced by a qualified electrician.
B The appliance must not be operated
unless it is repaired! There is the risk of
electric shock!
24