Adjusting The Feet - Beko WMA 767 W Installation & Operating Instructions And Washing Guidanse

Appropriate place foer instal-
lation
Install the appliance in environments
without risk of freezing in a stable and
even position.
A If there is risk of freezing, discharge all
the remaining water at the end of the
program.
A Floor must be capable enough to carry
the load on it.
For example, if the washing machine and
a drier is placed on top of each other, their
approximate weight together might reach
180 kg – when they are full.
Important:
• Do not stand appliance on the power
cable.
• Keep at least 1cm distance to walls of
other furniture.
• Place the machine on a sound surface;
do not locate it on a long nap rug or
surfaces alike.

Adjusting the feet

A Don't use any tool to loosen the lock
nuts to avoid damaging them.
1. Loosen the lock nuts on the feet.
2. Adjust them until the machine stands
evenly and firmly.
3. Important: Squeeze all lock nuts again.
Connecting to the water
supply.
Important:
• Keep the permissible water pressure in
mind (see "Technical specifications").
Attach a pressure reducing valve if
water pressure is higher.
• As the water pressure will be
insufficient, do not attach to a heater
(water heater).
• Use only the new hose supplied with
the machine, not an old existing one!
• Be sure that the hoses do not have
sharp bends.
A Do not use a tool to tighten it.
• The special hoses supplied with the
machine are connected to the water
intake valves on the machine. The red
hose or the hose with red sign is for the
hot water inlet and the blue hose or the
hose with blue sign is for the cool water
inlet.
• In order to prevent water leakage that
may occur at the connection points,
there are rubber sealings (4 sealings for
the models with double water inlet and
2 sealings for other models) attached
to the hoses or put in the packaging.
These sealings should be used at both
connection ends of the hoses. Sealings on
the machine side should sit on the hose
filter channel.
• Do not connect a product with single
water inlet to the hot water tap. Otherwise,
product may switch to protection.
1. If it is not attached already, screw
tightly the bent end of the network
hose on the rear panel of the machine
by hand.
2. Tightly attach the network hose to the
tap by hand.
3. Turn the water tap all the way on and
check all connections for leaks; Turn
the water tap off again. Correct the
positions of seals and screw couplings,
if necessary.
23