Installation; Prior To Use - Kenmore ELITE 795.7105 Series Use And Care Manual

INSTALLATION
• To minimize noise and vibration, the refrigerator
MUST be installed on a solidly constructed floor.
• Carpeting and soft tile surfaces are not
recommended.
• Never install the refrigerator on a platform or
weakly supported structure.
1. To avoid vibration, the unit must be leveled.
If required, adjust the leveling legs to compensate
for unevenness of the floor. The front should be
slightly higher than the rear to aid in door closing.
Leveling legs can be turned easily by tipping the
cabinet slightly. Turn the leveling legs clockwise
( .L._ ) to raise the unit, counterclockwise ( _,'_" )
to lower it.
(See Leveling and Alignment: on page 17.)
2. Install this appliance in an area where the
temperature is between 55°F (13°C) and 110°F
(43°C.) If the temperature around the appliance is
too low or high, cooling ability may be adversely
affected.
3. Too small a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at least 24
inches (61 cm) in front of the refrigerator to open
the doors.
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off all
dust accumulated during shipping.
2. Install accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are
packed together to prevent possible damage
during shipment.
3. Let your refrigerator run for at least 2 or 3 hours
before putting food in it. Check the flow of cold air
in the freezer compartment to ensure proper
cooling. Your refrigerator is now ready for use.
I
10