Kenmore 795.751924 Owner's Manual page 29

,
CONNECT THE TUBING TO THE
REFRIGERATOR
Removing and Replacing Valve Cover
NOTE:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
1. Loosen screw on top of plastic cover.
4. Insert the tube into the valve and fasten with wrench
as shown in the figure below.
Tubing
A CAUTION: Check to see if water dripping occurs at
water line connections.
5. Bend the tube upwards and fasten it into the clamp
provided to hold it in position. Replace the cover
and tighten the cover screw.
2. Lift off the cover by slightly pushing up.
Tubing
Clamp
3. Place a compression nut and a ferrule(sleeve) onto
the end of tubing.
_ ompression Nut
Ferrule (sleeve)
29