Water Filter - Kenmore 795.5131 Series Use And Care Manual

WATER FILTER
CHANGE FILTER
* Filter Reset: When the Filter Reset icon turns on,
you have to change the water fiiten Press the
Filter
Reset button for 3 seconds to turn the icon off.
HOLD 3 SECS
Before removing or installing the wafer filter
1. IMPORTANT: Turn off household wafer supply.
2.Take out the fop shelf and move if to the lowest level.
Removing the wafer filter
For filter replacement, remove aid filter by turning it
counterclockwise a quarter turn and pulling it down.
NOTE: The subsfffufe cap must be retained for fhe fufure.
If fhe filler is removed and nor replaced, if is necessary fo
reinstall fhe substitute cap fo prevenf water leaks from fhe
filter housing.
3.Push the water filter up into the filter receptacle and rotate
it clockwise to loci<
it into place. Once installed correctly,
the lock
symbol I_
should
be facing you and you
should
not be able to rotate the filter clockwise any more.
NOTE: After installation, if you notice that the lock symbol t_
is not facing you or you can continue to rotate the filter
clockwise; remove the filter and repeat installation to prevent
water leaks.
After insfallng the water filter
1. Replace the shelf to the initial position.
2.After installing filter, turn on household water supply.
3.Dispense 2.5 gallons (9.46 liters) of water to purge the
system, depressing and releasing the dispenser pad in
cycles of 30 seconds ON and 60 seconds OFF. Open the
refrigerator door and check the shelf area for water leaks.
To purchase replacement water filters, caii
1-800-4-MY-HOME ®.
Insfallng the wafer filter
1. Remove the red cap from the fitter.
2.Hold the filter with the unlock symbol E3 _ facing towards
you as shown in the figure below. Insert the filter into
the filter receptacle on the right side of the refrigerator
compartment.
f
IiOOiIl
22