Identification Of Controls; Multi Brand Remote Control - Toshiba SD-V594SC Service Manual

Introduction
Identification of controls (Continued)
The instructions in this manual describe the functions on the remote control. See the page in
Remote control
DVD/VCR button 13
* TV button 14
CALL button 11
* DISPLAY button
11
* CH / button 14
ZERO RETURN button 37
JUMP button
50
CM SKIP button 36
ZOOM button
50
TOP MENU button 54 59
( )
Direction buttons / / / 13
SET+/- buttons
28
CH+/- buttons 13
CANCEL button 31
CLEAR button
50
PLAY button 35 47
PAUSE/STILL button 36 48
REV button 35 49
SKIP button 49 FWD
VISS - button 38
VCR MENU button 28
SETUP button
63
MARKER button 51
USB
COUNTER RESET button 37
ANGLE button
54 59
ATR button 36
SUBTITLE button 56
SP/SLP button 39
PLAYMODE button
52
DVD/USB button 58
A-B RPT button
52
EJECT button (VCR) 34
OPEN/CLOSE (DVD) 47
DVD MENU button
Use the MENU button to display the menu included on
many DVD video discs. To operate a menu, follow the
instructions in "DVD Menu." #"
12
Introduction

Multi brand remote control

This remote control can be compatible with various brands of TV/
Cable box/DSS ® satellite receiver by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
Setting TV control codes
1 Press TV to set the remote control operating
your TV.
2 While holding down PROGRAM, enter the two
digits of your TV's brand code (listed on the
right) using Number buttons (0-9), then release
PROGRAM.
Point the remote control at your TV and use each button
listed below to make sure that your TV is operated
correctly.
POWER To turn the TV on or off.
CH M M M M M /? ? ? ? ?
To select TV channels in the upper
or lower direction.
VOL +/- To adjust the sound level.
INPUT SELECT To select an external source such
as a VCR.
Direct channel
To select TV channels. When select-
selection buttons
ing channels 1 to 9, first enter 0 and
(0-9)
then desired number.
100 To substitute for 100 channel key.
DISPLAY To turn TV's screen display on or
off.
ENTER To use for the TV's ENTER key.
Important
Some TV's may not respond to all the operations above,
or may not be operated at all with this remote control. In
this case, operate your TV with its own remote control.
Notes:
• For some brands, several control codes (brand codes) are al-
located. Try each of them until the buttons work on your TV.
• If you replace the remote control's batteries, set the brand code
again.
14
for details.
* POWER button 13
CABLE BOX button 15
* Direct channel selection
buttons (0-9) 13
Number buttons (0-9) 14
* 100 button 14
* VOL +/- buttons 14
* INPUT SELECT button 14
PROGRAM button 14
DVD
DVD MENU button 54 59
* ENTER button 28 63
RETURN button 63 70
STOP button 35 47
FWD button 35 49
49
SKIP button
VISS + button 38
36 49
SLOW button
CLOCK/COUNTER button 38
HDMI button 22
44
AUDIO SELECT button
AUDIO button 55
DVD/VCR SELECT button 27 47
TV/VCR button 27
REC/OTR button 39 41
TIMER REC button 42
*TV control buttons
The various brands of TV listed on page 14 can be operated
with this remote control. There may be some TV models that
cannot be operated with this remote control. If this is the case,
use the original remote control supplied with the TV.
•CABLE BOX control buttons
The various brands of CABLE BOX listed on page 15 can
be operated with this remote control. There may be some
CABLE BOX models that cannot be operated with this
remote control. If this is the case, use the original remote
control supplied with the CABLE BOX.
POWER
TV
0-9
100
DISPLAY
INPUT SELECT
PROGRAM
VOL +/-
ENTER
CH M M M M M /? ? ? ? ?
Table of TV brand codes
Brand name Brand Code Brand name Brand Code
of your TV of your TV
Toshiba 01 Penney 01, 02, 07, 11, 12
Bell & Howell 09 Philco 10
Carver 10 Philips 10
Celebrity 03 Pioneer 16
Citizen 12 Princeclub 12
Curtis Mathes 09, 12
Prism 07
Dumont 14 Proscan 02
Electro band 03 Proton 11
Emerson 09,11 Pulser 14
Fisher 09 Quasar 07, 15
GE 02, 07, 11 Radio Shack 13
Gibralter 14 RCA 02
Goldstar 11 Realistic 09, 11, 13
Hallmark 11 Runco(NEC) 14
Hitachi 06 Samsung 11, 12
Infinity 10 Sanyo 09
JBL 10 Scotch 11
JCB 03 Scott 11
JVC 05
Sears 01, 02, 09, 10, 11
LXI 01, 02, 09, 10, 11 Sharp 08, 13
Magnavox 10
Sony 03
Marantz 10 Soundesign 11
Megatron 06, 11 Supreme 03
Memorex 04, 09, 11 Sylvania 10
MGA 04, 11 Tandy 08
Midland 02,07, 14 Technics 07, 15
Mitsubishi 04, 11 Techwood 07
Motorola 08 Teknika 04,10,12
MTC 12 TMK 11
NAD 01, 11 Victor 05
Nikko 11 Vidikron 10
Optimus 09 Vidtech 11
Optonica 08 Wards 10, 11,13
Panasonic 07, 10, 15 Zenith 14
Inserting batteries
1 2
Open the battery compart- Install two "AAA" batteries
ment cover in the direction of (supplied), paying attention to the
the arrow. polarity diagram in the battery
compartment.
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with
new ones.
• When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix
battery types or use new and used batteries in combination.
• Always remove batteries from remote control if they are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.
Remote control basics
• Press DVD/VCR to operate the DVD/VCR.
• Press POWER to turn the DVD/VCR on or off.
• Select your desired operating mode (DVD or VCR) using DVD/VCR SELECT.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press CH + or CH - to move through the channels one channel at a time.
• The / / / are also used to navigate on-screen menu system.
• You can directly access specific channels using Direct channel selection buttons (0-9).
• Each press of DVD/VCR SELECT on the remote control, switches the screen between the VCR screen (VCR mode)
and the DVD screen (DVD mode).
Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of approx. 7 meters.
Setting Cable box/DSS ® satellite
receiver control codes
1
Press CABLE BOX to set the remote control
®
operating your Cable box/DSS satellite receiver.
2
While holding down PROGRAM, enter the two
digits of your Cable box/DSS ® satellite receiver
brand code (listed on the right) using Number
buttons (0-9), then release PROGRAM.
Point the remote control at your Cable box/DSS ®
satellite receiver and use each button listed below to
®
make sure that your Cable box/DSS satellite receiver
is operated correctly.
®
POWER To turn the Cable box/DSS satel-
lite receiver on or off.
CH M M M M M /? ? ? ? ?
To select cable/satellite channels in
the upper or lower direction. (Not
applicable to some brands of cable
box/satellite receiver.)
Number buttons (0-9) To select desired channels to record.
ENTER To use for the Cable box's ENTER key.
(Some cable boxes require you to use 100 button as the
enter button.)
Important
Some Cable box/DSS ® satellite receiver may not respond
to all the operations above, or may not be operated at all
with this remote control. In this case, operate them with
its own remote control.
Notes:
• For some brands, several control codes (brand codes) are al-
located. Try each of them until the buttons work on your Cable
box/DSS ® satellite receiver .
• If you replace the remote control's batteries, set the brand code
again.
3
Replace the compartment
cover.
Approx. 7 meters
13
Table of Cable box brand codes
Brand name of Brand Code
Brand name of Brand Code
your cable box your cable box
Toshiba 36 Philips 4, 13, 20,
21, 22, 23,
Anvision 13, 20, 21,
24, 25, 26,
22, 23, 24,
58, 62, 84
25, 26, 58,
62, 84 Pioneer 5, 6, 78
Archer 1, 20, 21, Pulsar 30, 42, 44,
29, 42, 44, 52, 63, 88
63, 88, 91
Randtek 13, 20, 21,
Cablestar 13, 20, 21, 22, 23, 24,
22, 23, 24,
25, 26, 58,
25, 26, 58, 62, 84
62, 84
RCA 6, 8, 16, 17
Cableview 30, 42, 44,
Realistic 44, 88
52, 63, 88
Regal 14, 23, 41,
Citizen 30, 42, 44,
84
52, 63, 88
Regency 26, 28
Curtis 8, 9, 56, 61
Rembrandt 29, 32, 38,
Diamond 1, 20, 21,
39, 42, 44,
29, 42, 44,
88
63, 88, 91
Samsung 4, 6, 32,
Eagle 13, 20, 21,
42, 78
22, 23, 24,
Scientific Atlanta 8, 9, 56, 61
25, 26, 58,
62, 84
Sheritech 27
Eastern 26, 28
SL Mark 4, 6, 32,
42, 78
GC Brand 30, 42, 44,
52, 63, 88 Sprucher 6, 8, 16, 17
Gemini 4, 30, 85
Stargate 4, 6, 30, 32,
42, 44, 52,
General 1, 2, 3,
63, 78, 88
4, 31, 34,
Instrument
55, 83, 85,
Sylvania 19
91
Teknika 74
Hamlin 14, 15, 28,
Telecaption 77
41
Teleview 4, 6, 32,
Hitachi 31, 79, 80
42, 78
Jerrold 1, 2, 3,
Texscan 18, 19
4, 31, 34,
Tocom 1, 33, 34,
55, 85, 91
42, 48, 49,
Macom 31, 79, 80
73, 91
Magnavox 13, 20, 21,
Unica 1, 20, 21,
22, 23, 24,
29, 42, 44,
25, 26, 58,
63, 88, 91
62, 84
Universal 29, 42, 43,
Movietime 29, 32, 38,
44, 52, 63,
39, 42, 44,
82, 88
88
Videoway 7, 23, 45,
NSC 29, 32, 38,
50, 84
39, 42, 44,
Viewstar 13, 20, 21,
88
22, 23, 24,
OAK 10, 11, 12,
25, 26, 58,
13, 46
62, 84
OAK Sigma 10, 11, 12,
Warner Amex 6
13, 46
Zenith 7, 23, 45,
Panasonic 6, 8, 16, 17
50, 84
Table of DSS ® satellite receiver brand codes
Brand name Brand code Brand name Brand code
Toshiba 99 Draker 94
RCA 98 Primestar 93
Sony 97 Hitachi 92, 89
Magnavox 95, 96
Panasonic 90
15