Demo Mode; Selecting Demo Mode; Main Functions; Exiting Demo Mode - Electrolux EUROFLEC Service Manual

Demo mode is used to demonstrate the operation of the user interface (control panel) without activating the
various loads (compressor, fans, heating elements).
To select Demo mode, press buttons b, d and e simultaneously for at least 2 seconds within 15 seconds
after switching the appliance off by pressing the ON/OFF button (e).
When Demo mode is selected, the buzzer sounds four times and the LEDs flash simultaneously four times.
The main functions of Demo mode are as follows:
1. the light in the refrigerator compartment must switch on when the door is opened and switch off again
when it is closed.
2. the lights in the thermostat knobs switch on.
3. the LEDs light.
4. when the RAPID FREEZING button is pressed, the LED is steady ON.
Alarm buttons:
"Temperature alarm" button (c):
1. When pressed once: the LED begins to flash and the buzzer sounds (remains activated also when the
door is closed).
2. When pressed twice within 10 seconds: The LED remains lit (fixed) and the buzzer switches off.
3. After 10 seconds, both the LED and the buzzer are switched off.
The "door" alarm button (b) operates in the same way as the "temperature" alarm (see above).
To exit Demo mode, it is necessary to disconnect the appliance from the power supply.
Press the ON/OFF button (e) for at least 2 seconds to enter Demo mode with the appliance switched off
(Demo OFF operation).
EUROFLEC

8. Demo Mode

8.1. Selecting Demo mode

8.2. Main functions

8.3. Exiting Demo mode

27/36