Kenmore ELITE 790.4102 Series Use & Care Manual page 18

Consumer Defined Control
Note: The Consumer Defined Control features are adjustments to the control that will not affect cooking results. These
include the Oven Lockout, Temperature Display and Silent Control Operation features
Setting Oven Lockout Feature
The _._oP_ pad controls the Oven Lockout feature. The Oven Lockout feature automatically locks the oven door and
prevents the oven from being turned on. It does not disable the clock, Kitchen Timer or the interior oven lights.
INSTRUCTIONS
To activate the Oven Lockout feature
1. Press and hold _ for 3 seconds.
2. After 3 seconds "Loc" will appear, a beep will sound and
"DOOR LOCKED" will flash in the display. Once the oven door
is locked the "DOOR LOCKED" indicator will stop flashing and
remain on along with the "Loc" (Figure 1).
To reactivate normal oven operation:
1. Press and hold _oP_) for 3 seconds. A beep will sound. The
"DOOR LOCKED" will flash in the display until the oven door
has completely unlocked (Figure 2).
PRESS DISPLAY
for 3
seconds
Figure 1
Q for 3
seconds
Figure 2
2. The wall oven is again fully operational.
Setting Silent Control Operation
The DELAYTIME _ and FLEX CLEAN _ pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent operation press
and hold _. '.... --.-- will appear and "DELAY" will flash in the
display (Figure 3). After 7 seconds "SP" (Speaker) will appear
in the display. (Figure 4)
2. Press @ to switch between normal sound operation and
silent operation mode. The display will show either "SP" (Figure
4) or ":=="(Figure 5).
.
If "SP" appears (Figure 4), the control will operate with normal
sounds and beeps. If ":= ="appears (Figure 5), the control is in
the silent operation mode.
Press to accept the change or press to reject the
change.
PRESS DISPLAY
@
for 7 seconds
@
Figure 3
Figure 4
Figure 5
Note: The control will always beep at the end of a kitchen timer and will beep when a set temperature has been reached,
even if the control is set to silent operation.
18