1
D
2
E
Tool: 5 mm Allen key
INVACARE
®
XLT
HEAD AND NECKREST
1. Head and neckrest for biangular backrest
The head and neckrest are mounted on the push
bar.
C
Height adjustment
Loosen the knobs (A and/or B) and adjust to
desired height. Retighten the knobs again.
Angle adjustment
Loosen the handle (C) and/or the screws (D)and
set the desired angle. Retighten the handle and the
A
screws.
B
2. Adjust the angle of the sides of the head-
rest
Adjust the angle of the "wings" of the headrest by
unzipping the zip at the bottom of the neckrest
and loosening the screw (E). Set the required angle
and close the zip.
A head and neckrest may affect the balance
of the wheelchair when mounted behind the
backrest. Please control the balance of the
wheelchair and adjust the rearwheels back-
wards for increased stability.
39
Need help?
Do you have a question about the XLT Dynamic and is the answer not in the manual?
Questions and answers