Kenmore 790.927 Use And Care Manual page 16

Setting Oven Controls
Setting Clock
When the appliance is first powered up, ]2:00 wiil flash in
the display (See Fig. 1). The time of day must first be set
before operating the oven.
Fig. ]
Example; to set the clock to 1:30:
(_) key pad.
1. Press
2. Enter | 3 0 using numeric key pads.
3. Press
;START *
Important note:
The clock cannot be changed when a Cool< Time or Delay
Start feature is active.
Setting Timer
The minute timer allows you to track your cooking times
without interferring with the cooking process. The timer
may be set from ] minute up to 11 hours and 59 minutes.
Example; to set the timer for 5 minutes:
1. Press Timer Set/Off key pad.
2. Enter 5 using numeric key pad.
3. Press START k ey pad to start timer.
To cancel the timer when active press Timer Set/Off
key pad again.
Important notes:
* The timer does not start or stop the cooking process. It
serves as an extra minute timer in the kitchen that will
beep when the set time has run out. The timer may be
used alone or while using any of the other oven functions.
The timer wiii display hours and minutes until I hour
remains. When less than ] hour remains, the display wiii
count down in minutes and seconds. Once the timer has
less than ] minute remaining only seconds wiii display.
When the timer is active during a cooking process, the
minute timer will show in the display. To view the
information of any other active oven function, press the
key pad once for the other function to view the status.
Add I Minute
Use the Add ] Minute to set additional minutes to the timer.
Each press of the
key
pad wili add ] additional minute. If
Add ] Minute key pad is pressed when the timer is not
active, the timer wili activate and begin counting down
from ] minute.
Example; to add 2 minutes to the timer:
Press Add I Minute key pad twice.
Setting 12 or 24 hour display mode
The clock display mode allows you to choose between 12
or 24 hr modes. The factory pre-set clock display mode is
12 hours.
Example; to set 12 or
24 hour display mode:
1. Press and hold _ key pad for 6 seconds.
2. Press Flex (::lean key pad to toggle between 12 hour
(Fig. 2) or 24 hour (Fig. 3) display modes.
3. Press ST_ tO accept choice.
Fig. 2 Fig. 3
Changing
between continuous
bake setting or
12-Hour
Energy
Saving feature
The oven control has a factory preset built-in 12 Hour
Energy Saving feature that will turn off the oven if the oven
is left on for more than 12 hours. The control may be
programmed to override this feature to continuously bake.
Example; to change between continuous bake or |2-Hour
Energy Saving feature:
1. Press and hold Timer Set/Off key pad for 6 seconds.
2. Press Flex Clean to toggle between 12 Hour Energy
Saving (Fig. 4) or continuous bake (Fig. 5) feature.
3. Press STA_ tO accept choice.
Fig. 4 Fig. 5
]6