Kenmore 790.927 Use And Care Manual page 10

Before Setting Surface Controls
Types of cooktop surface elements
The ceramic glass cooktop has radiant surface elements
located below the surface of the glass. The patterns on the
ceramic glass will outline the size and type of element
available.
The single radiant element or elements will have one round
outline pattern shown on the cooktop. The warmer zone
feature located on the center rear area of the cooktop uses
one round outline and is designed to keep food warm only.
The dual (some models) radiant element allows the user to
set the smaller inner portion as a single element or both
inner and outer portions may be set to heat together (See
Fig. 1).
The trlple (some models) radiant element feature has 3
element portions and may be set to heat as 1 (single)0 2
(dual) or 3 (triple) element portions together (See Fig. 2).
WARMER ZONE EtE_NT ON
@ @ @ ©
Center Right Rear Right Front
Warmer Zone Single Dual element control
control element
(some models) control
Fig. 1 (models with right front dual element)
WARMER ZONE _L_NT ON
@ @ @
Center Right Rear Right Front
/? TRIPLE
ELEMENT
Turbo Boil feature (some models)
Your appliance may be equipped with one or two elements
on the ceramic cooktop marked TURBO BOIL.
These higher wattage radiant elements are best used when
bringing larger quantities of liquid to temperature and
when preparing larger quantities of food.
Home Canning
Be sure to read and observe all the following points when
home canning with your appliance. Check with the USDA
(United States Department of Agriculture) website and be
sure to read aii the information they have available as weii
as follow their recommendations for home canning
procedures.
* Use only quality fiat bottom canners when home canning.
Use a straight-edge to check canner bottom.
* Use only a completely flat bottom canner with no ridges
that radiate from the bottom center when home canning
using a ceramic cooktop.
Make sure the diameter of the canner does not exceed 1
inch beyond the surface element markings or burner. It is
recommended to use smaller diameter canners on
electric coil and ceramic glass cooktops.
* Start with hot tap water to bring water to boil more
quickly.
* Use the highest heat seating when first bringing the water
to a boil. Once boiling is achieved_ reduce heat to lowest
possible setting to maintain that boil.
NEVER place or straddle a cooking utensil over 2
different surface
cooking
areas at the same time.
This
will
cause uneven heating results and may cause the
ceramic cooktop to fracture.
Warmer Zone Single
control element
(some models) control
Triple element control
Fig. 2 (models with right front triple element)
10