Deleting A Registered Device; Bluetooth Compatibility Check Mode - JVC KD-X250BT Instruction Manual

Bluetooth connection
Connecting/Disconnecting a
registered device manually
To connect
1
(Hold)
2 Select <CONNECT>.
3 Select the desired device.
"CONNECTING" "[Device Name]" scrolls on the
display when the unit is connecting to the device.
"CONNECTED" "[Device Name]" scrolls on the
display when the device is connected.
4 Press MENU to exit.
To disconnect
1
(Hold)
2 Select <DISCONNECT>.
3 Select the desired device.
"DISCONNECT" "[Device Name]" scrolls on the
display when the device is disconnected.
4 Press MENU to exit.

Deleting a registered device

1
(Hold)
2 Select <DELETE YES>.
"DELETED" appears when the device is deleted.
3 Press MENU to exit.
12 | ENGLISH
<BLUETOOTH>
<PHONE>/<AUDIO>
<CONNECT>
<BLUETOOTH>
<PHONE>/<AUDIO>
<DISCONNECT>
<BLUETOOTH>
<DELETE PAIR>
[Device name]
<DELETE YES>
Bluetooth compatibility check
mode
You can check the connectivity of the supported
profile between the Bluetooth device and the
unit.
1 Enter check mode.
(Hold)
"BLUETOOTH" "CHECK MODE" appears.
"SEARCH NOW USING PHONE" "PIN IS 0000"
scrolls on the display.
2 Search and select "JVC UNIT" on the
Bluetooth device within 3 minutes.
3 Perform pairing (A), (B) or (C) depending
on what appears on the display.
(A) "PAIRING" "XXXXXX" (6-digit passkey):
Ensure that the same passkey appears on the unit
and Bluetooth device, then operate the Bluetooth
device to confirm the passkey.
(B) "PAIRING" "PIN IS 0000":
Enter "0000" on the Bluetooth device.
(C) "PAIRING":
Operate the Bluetooth device to confirm pairing.
After pairing is successful, "PAIRING OK"
"[Device Name]" appears and Bluetooth
compatibility check starts.
If "CONNECT NOW USING PHONE" appears,
operate the Bluetooth device to allow
phonebook access to continue.
The connectivity result flashes on the display.
"H.FREE OK" *1 and/or "A. STREAM OK" *2
"[Device Name]": Compatible
"CONNCT FAIL" "TRY CONNECT": Not
compatible
*1 : Compatible with Hands-Free Profile (HFP)
*2 : Compatible with Advanced Audio
Distribution Profile (A2DP)
After 30 seconds, "PAIRING DELETED" appears to
indicate that pairing has been deleted, and the
unit exits check mode.
To cancel check mode, turn off the unit by
pressing and holding
Delete the pairing on the Bluetooth device
before pairing with this unit. (
(Hold about
3 seconds)
SOURCE.
page 11)