Fcc Part 90 Requirements - Lipman NURIT 8000 Installation Manual

If this device is malfunctioning, it may be causing
harm to the telephone network; this device should be
disconnected until the source of the problem can be
determined and until repair has been made. If this is
not done, the telephone company may temporarily
disconnect service.
The telephone company may make changes in its
technical operations and procedures; if such changes
affect the compatibility or use of this device, the
telephone company is required to give adequate notice
of the changes. You will be advised to file a complaint
with the FCC.
If the telephone company requests information on
what equipment is connected to their lines, inform
them of:
•
•
•
•
The Ringer Equivalence Number (REN) is used to
determine how many devices can be connected to your
telephone line. In most areas, the sum of the RENs of
all devices on any one line should not exceed five (5). If
too many devices are attached, they may not ring
properly. To be certain of the number of devices that
may be connected to the line, as determined by the
total RENs, contact the telephone company to
determine the maximum REN for the calling area.

FCC Part 90 Requirements

This device may contain a radio transceiver module,
(FCC ID number is located on the bottom of the
terminal), operating under Part 90 of the FCC rules in
a licensed part of the radio spectrum. Qualified
personnel must perform service or repairs to the radio
portion of this device. Any unauthorized modification
to the radio module, shielding, or antenna system may
void the user's authority to operate this device.
Installation Manual
SanDiegoMerchantServices.net 858-335-2992
The telephone number to which this unit is
connected
The AC Ringer Equivalence Number: 00B
The USOC jack required: RJ-11C
The FCC Registration number: (See the
underside of the unit and/or applicable unit
documentation for this number.)
3