Lipman Nurit 8000 Quick Reference Manual

05BAM066_N8000.Ret.B.1.Doc
Manual Credit Card Sale
›
Enter Acct Number +
›
Enter
Exp. Date +
Paymt
›
Enter
Amount +
Paymt
Card Present?
›
Enter
Press for Yes
Paymt
›
Or for No
Menu
Cancel
›
Enter
Enter Zip Code +
Paymt
›
Enter
Street Address +
Paymt
›
Enter CVV2, CVC2, or CID
Enter
Code* +
Paymt
If code is not known or not present, press
and choose the appropriate numeric response.
›
Enter Order Number* +
Enter invoice number or just press the
and then press the Enter key.
Paymt
*These items above prompt if the card is not present. Discover
cards will prompt when the card is present as well. The AVS
and CVV2 or CID response will print on the receipt.
Credit Card Sale
›
Swipe Card
›
Press Menu for Credit Card
Cancel
if Prompted, or Skip to Next
Step
›
Amount + Enter
Paymt
NOTE:
The Nurit 8000 is a wireless terminal with an internal radio antenna and battery pack. The terminal will turn itself off if idle for more
than one minute to conserve the battery power. To turn the terminal back on, press and hold down
the battery, plug the terminal into a standard power outlet using the power pack provided. It is recommended that the terminal be
charged for 12 hours upon receipt, and about two hours for recharges.
To manually turn the terminal off, press
There is a battery status graphic in the lower left corner of the screen. A radio connection and signal strength indicator is in the
lower right corner. When first powered on, this will say "RAD FAIL." After a radio connection is made (5-40 seconds) a number
should display here to indicate the strength of the connection. A signal of at least 14 is recommended.
* CVV2 (also CVC2 and CID) codes are often requested for manually entered transactions. These codes normally appear on the
back of the card as the last three digits on the right of the signature panel, directly below the mag stripe.
Use numbers only for street address.
-
Terminal will prompt for Clerk ID and invoice number if those options are activated.
4/18/05 3:18 PM
Nurit 8000
Quick Reference Guide
Credit Card Refund
›
Enter
Press
Paymt
Until Credit...Return
Appears on the Screen
›
Swipe Card
Or Enter Acct Number +
›
Enter
Exp. Date +
Paymt
›
Enter
Amount +
Paymt
Enter
Paymt
Enter
Paymt
1 key
Debit Sale
›
Swipe Card
›
Enter
Press for Debit Card
Paymt
Or
›
Enter
Press
Paymt
Until Debit...Sale Appears on
the Screen Then Swipe Card
›
Amount + Enter
Paymt
›
Cash Back +
Enter
Paymt
›
Press Enter if No Cashback
Paymt
›
PIN Number +
and at the same time.
On/Off
F
Page 1
›
Press
Until Credit...Void/Sale
Appears on the Screen
Press
›
Enter
Swipe Card
Paymt
Or Enter Acct Number +
›
Exp. Date +
›
Amount +
The terminal will look for a transaction that matches the data
entered to VOID, or it will read. "Trans not found" if no match.
Forced Sale
›
Press
Until Credit...Forced
Appears on the Screen
›
Swipe Card
Or Enter Acct Number +
›
Exp. Date +
›
Amount +
›
Enter Auth Number +
Use the six digit authorization number previously obtained
for this transaction. The receipt will read "Ticket Only".
Enter
Paymt
On/Off
R
ETAIL
Voids
again to VOID a Return, or again
to VOID a Forced Sale.
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
for two seconds. To charge