ProForm 595 lt User Manual page 8

3. Identify the Right Upright (78) and the Right
Upright Spacer (80), which are marked with
"Right" stickers. Insert the Upright Wire (77)
through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (85).
With the help of a second person, hold the Right
Upright (78) near the Base (85). See the inset
drawing. Tie the wire tie in the Right Upright se-
curely around the end of the Upright Wire (77).
Then, pull the other end of the wire tie until the
Upright Wire is routed completely through the
Right Upright.
4. Hold a Bolt Spacer (79) inside the lower end of
the Right Upright (78). Insert an M10 x 96mm
Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (79), M10 x
96mm Bolt (5), and M10 Star Washer (8).
Hold the Right Upright (78) against the Right
Upright Spacer (80). Be careful not to pinch
the Upright Wire (77). Partially tighten the M10
x 96mm Bolts (5); do not fully tighten the
Bolts yet.
Press a Base Cap (82) into the Base (85).
3
77
78
Wire
77
Tie
4
78
8
Wire Tie
78
77
80
85
5
8
77
79
82
79
80
85