Table of Contents
Advertisement
Notes on Using Wireless Connection
■
Wired LAN
Use straight or crossover LAN cable that is compatible with category 5 or above.
Whether straight cable, crossover cable or both can be used varies depending on the system configuration. For details,
consult your system administrator.
When setting up the Display at a place, where electric statistic occurs often, take a sufficient anti-static measure before
start using.
When the Display is used at a location, where static electricity occurs often, such as on a carpet, communications of
the DIGITAL LINK and the wired LAN are disconnected more often. In that case, remove static electricity and the noise
source that may cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired LAN.
In rare cases, the LAN connection is disabled due to static electricity or noise. In that case, turn off the power of the
Display and the connected devices once and then re-turn on the power. Connect the DIGITAL LINK and the LAN.
The Display may not work properly due to strong radiowave from the broadcast station or the radio.
If there is any facility or equipment, which outputs strong radiowave, near the installation location, set up the Display
at a location sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to the DIGITAL LINK
terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.
■
Available wireless LAN channels
The channels (frequency range) that can be used differ according to the country or region. Refer to the table below.
Country or region
Global
The frequency and channel differ depending on the country.
The passive scanning is performed by changing radio to the channel being scanned in each country.
Please use the wireless LAN feature in compliance with the laws of each country.
■
For Mexico:
Operation of this equipment is subject to the following two conditions:
(1) this equipment might not have a harmful interference and
(2) this equipment must accept any interference, including one that might cause it to malfunction
■
For Jamaica:
•
This product contains Type Approved Modules by Jamaica.
8
Standard
IEEE802.11a/n
IEEE802.11b/g/n
Channels used
Frequency band (Center frequency)
Passive scanning
Passive scanning
5.180 GHz - 5.825 GHz
2.412 GHz - 2.472 GHz
Advertisement
Table of Contents
