9.2.3.5. Control & Cad Cell
Troubleshooting Guide
Symptom
Burner runs all the time
No combustion
Ohmmeter pointer above 2
Ohmmeter pointer below 3
Primary wont lock out
Ohmmeter pointer below 50
Burner wont start
Burner runs with
thermostats contacts open
SECTION 10.
Replacement Parts
Possible Cause
10.1 Ordering Information
Defective primary
control
No power to the
primary.
Limit switch turned
off.
Defective limit
switch.
Bad wire connection.
Bad burner motor.
No power from fuse
box.
Defective primary
10.2 Parts List
Key
Partly plugged
No. Description
nozzle.
Cad cell dirty.
Cad cell misaligned.
Defective cell.
Not enough
combustion air.
Cad cell sees too
much light.
Adjust alignment.
Defective primary
Stray light in burner
housing.
Defective cad cell.
Open circuit in
thermostat wiring.
Dirty thermostat
contacts.
Defective thermostat.
Short circuit in
thermostat wiring
NOTE:
FUEL SYSTEMS
ELECTRICAL SYSTEM
WATER SYSTEMS
POOL PRODUCTS
Model ORDER
No.
PART NO.