Advertisement
Hold coupllng
nut and regulator
as shown for proper connection
to LP tank valve.
Leak Testing
Valves,
Hose and
Regulator
1. Turn all grill control knobs to OFF.
2. Be sure regulator
is tightly
connected
to LP tank.
3. Completely
open LP tank valve by turning
OPD hand wheel
counterclockwise.
If you hear a rushing sound, turn gas off
immediately.
There is a major leak at the connection.
Correct before proceeding
by calling
Sears for replacement
parts at 1-800-4-MY-HOME
®.
4. Brush soapy solution
onto areas where bubbles are shown in
picture below:
6. Turn the coupling
nut clockwise
and tighten
to a full stop. The
regulator
will seal on the back-check
feature
in the LP tank
valve, resulting
in some resistance.
An addltlonal
one-half
to
three-quarters
turn is required to complete
the
connection. Tighten
by hand only - do not use tools.
NOTE:
If you cannot complete
the connection,
disconnect
regulator
and repeat steps 5 and 6. If you are still unable to complete
the
connection,
do not use this regulator!
Call 1-800-4-MY-HOME
® for identical
replacement
parts.
/k
/k
" Do not insert any tool or foreign
objects
into the valve
outlet or safety
relief valve. You may damage
the valve
and cause a leak. Leaking
propane
may result in
explosion,
fire, severe personal
injury, or death.
" If a leak is detected
at any time, STOP and call the fire
department.
" If you cannot stop a gas leak, immediately
close LP tank
valve and call LP gas supplier or your fire department!
" Never attempt
to attach this grill to the self-contained
LP gas system of a camper
trailer
or motor home.
Never
remove
threaded
orifice at end of valve.
5. if "growing"
bubbles appear,
there is a leak. Close LP tank
valve immediately
and retighten
connections,
if leaks
cannot be stopped do nat try to repair. Call Sears for
replacement
parts at 1-800-4-MY-HOME
®.
6. Always
close LP tank valve after performing
leak test by
turning
hand wheel clockwise.
" Do not use grill until leak-tested.
6 o 464220311
Advertisement
