Table of Contents
Advertisement
Sideburner
[]
Loosenside burner in side shelf. To loosen, unscrewand remove two front screws and washers holding
sideburnerin place. Note: Do not loosenelectrode screw.
[]
Removeknob and bezelfrom sideburnercontrol valve. To remove,pull knob straightout from valve stem.
Unscrewbezel from valve face and set the two screws aside.
[]
Insert valve stem through hole in fascia. Attach bezel to fascia and valve face with previously
removed 2 screws.
[]
Place sideburner tube over the valve, making sure that valve is inside sideburner tube as shown.
[]
Reattach sideburner to sideburner shelf with the 2 previously removed screws and washers.
[]
Push control knob onto sideburner valve stem.
[]
Replace sideburnergrate.
[]
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.
[]
Unscrew igniter cap from control panel. Insert (1) AA battery (not provided) into battery slot with
positive end (+) facing outward. Screw igniter cap back onto panel.
20,640-01303702-3-58
Advertisement
Table of Contents
