Canon HF10 Instruction Manual page 101

[9] NEED TO RECOVER FILES FROM THE CARD. CHANGE THE POSITION OF THE CARD'S LOCK SWITCH.
- This message will appear the next time you turn on the camcorder if power supply was accidentally
interrupted while the camcorder was writing to the memory card and later the position of the card's LOCK
switch was changed to prevent erasure. Change the position of the LOCK switch (
[2] NO CARD
- There is no memory card in the camcorder.
[12] NO IMAGES
- There are no still images to play back.
[28] NO SCENES
- There are no scenes recorded in the memory selected.
[13] NOT AVAILABLE IN
- You pressed a button that cannot be used in
the button to set the camcorder to flexible recording mode.
[32] PROCESS CANCELED
- The process was canceled following user intervention.
[29] REACHED THE MAXIMUM NUMBER OF SCENES
- The maximum number of scenes has been reached. Delete some recordings (
[45] READING THE BUILT-IN MEMORY
- Reading data from the built-in memory.
[6] READING THE CARD
- Reading data from the memory card.
[30] SOME SCENES COULD NOT BE DELETED
- Movies that were protected/edited with other devices cannot be deleted.
[31] TASK IN PROGRESS DO NOT DISCONNECT THE POWER SOURCE
- The camcorder is updating the memory. Do not disconnect the compact power adapter or remove the battery
pack.
[35] THE CAMCORDER IS SET TO STILL IMAGE MODE
- You pressed
START/STOP
[8] THE CARD IS SET FOR ERASURE PREVENTION
- The LOCK switch on an SD or SDHC memory card is set to prevent accidental erasure. Change the position of
the LOCK switch (
[1] THE MEMORY CARD COVER IS OPEN
- After inserting a memory card, close the memory card slot cover by pulling it down until it clicks (
[34] TOO MANY STILL IMAGES DISCONNECT USB CABLE
- Disconnect the USB cable and decrease the number of still images on the memory card to fewer than 1,800.
If a dialog appeared on the computer screen, close it and then reconnect the USB cable.
[36] TRANSFER ORDER ERROR
- You attempted to set more than 998 transfer orders. Reduce the number of still images marked with transfer
orders.
[46] UNABLE TO RECOGNIZE THE DATA
- You transferred data to the camcorder recorded in a different television system (NTSC).
MODE
while recording still images (
107).
mode (while the button's blue light is on). Press
mode).
107).
38, 59) to free some space.
28).
101