Pride Mobility Go-Chair Owner's Manual page 27

Battery Condition Meter
The battery condition meter is located in front of the joystick. This
is a 10-segment illuminated display that indicates that the VSI is
turned on and also gives the battery status, the VSI status, and the
electrical system status.
n Red, yellow, and green lights lit: Batteries charged; VSI and
electrical system OK.
n Red and yellow lights lit: Charge batteries if possible; VSI and
electrical system OK.
n Red lights only lit or slow flash: Charge batteries as soon as
possible; VSI and electrical system OK.
n Rapid flash of lights: Indicates a fault in the VSI or the electrical
system. Refer to “VSI Error Codes.”
n Ripple side to side of lights: The joystick was not in the neutral
position when the controller was turned on. If you get “ripple side to
side of lights,” turn off the controller, allow the joystick to return to the
neutral position, then turn on the controller.
NOTE: If you still get “ripple side to side of lights,” contact
an authorised Pride Provider.
NOTE: When the batteries approach a discharged state, the
first red light will begin to slowly flash, reminding you the
batteries need to be charged immediately!
Speed Keys
The speed key controls the speed. Press the speed increase key to increase the speed. Press the speed decrease key to
decrease the speed. The speed setting is displayed on the maximum speed indicator.
NOTE: We recommend that the first few times you operate your Go-Chair, you set the speed to the slowest
setting until you become familiar with your new Go-Chair.
Horn Key
The horn key activates the horn.
Locking/Unlocking the VSI
The VSI has a feature that enables you to lock your Go-Chair to prevent unauthorised use.
To lock the VSI:
1. With the VSI switched on, press and hold the on/off key. After 1 second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
Go-Chair
V I I . O P E R A T I O N
www.pridemobility.com
Figure 19. VSI Controller Keypad
27