Your Go-Chair - Pride Mobility Go-Chair Owner's Manual

MANUAL FREEWHEEL LEVERS
The Go-Chair has a manual freewheel lever on each motor. Manual freewheel levers enable you to disable the motor brake
in order to push the chair.
WARNING! Do not use the Go-Chair while the brakes are disabled! Do not disable the brakes when
the Go-Chair is on an incline, as the unit could roll on its own, causing injury!
NOTE: The batteries will not charge in freewheel mode unless the battery box is removed from the power base.
NOTE: You must turn off the power before disabling the brakes, otherwise you may get an error code on the
controller. To clear this code, turn off the controller and place the Go-Chair in drive mode. Then turn on the
controller. The error message should be cleared. If not, contact an authorised Pride Provider.
To engage or disengage the drive motors:
1. Locate the levers on the rear section of the power base. See figure 7.
2. Push the two levers forward to enable the brakes.
3. Pull the two levers rearward to disable the brakes.
WARNING! It is important to remember that when your Go-Chair is in freewheel mode, the braking
system is disengaged.
ANTI-TIP WHEELS
The anti-tip wheels are an integral and important safety feature of your Go-Chair. They are bolted onto the frame at the rear
of the travel chair. See figure 7.
WARNING! Do not, under any circumstances, remove the anti-tip wheels from your Go-Chair.
Figure 7. Back of Power Base
Go-Chair
I I I . Y O U R
www.pridemobility.com
G O - C H A I R
MANUAL FREEWHEEL LEVERS
ANTI-TIP WHEELS
17