When Vertical Louver does not operate.
• Confirm that the Vertical Louver is normally geared with the shaft of
• If the regular torque is detected when rotating the Vertical Louver with
• Check the connecting condition of CN-U/D Connector
• Check the soldering condition(on PWB) of CN-U/D Connector
• Confirm that there is DC + 12V between pin (RED) of CN-U/D and
GND.
• Confirm that there is a soldering short at following terminals.
- Between
- Between
- Between
• Confirm the assembly conditions that are catching and interfering parts
38 Multi Air Conditioner
Stepping Motor.
hands
Normal
Check the operating circuit of the Vertical Louver
,
,
and
60
61
62
,
,
and
,
,
and
If there are no problems after above checks
in the rotation radial of the Vertical Louver
of MICOM
63
of IC01M
of IC01M
Cycle Troubleshooting Guide