Table of Contents
Advertisement
6.
The program will then give you a list of the
modifications that it will make to your
AppleWorks disk(s) and ask you if you want to
continue. If you want to go ahead and make these
modifications to your AppleWorks disk(s), hit the
"Y" key. If you don't want to make these
modifications, hit the "N" key to return to the
main menu.
7.
After the STARTUP disk has been successfully
modified, you may be prompted to remove it
from the disk drive and insert a COPY (write
enabled) of the AppleWorks PROGRAM Disk.
The volume directory name of this disk must be
the same as the STARTUP disk. Press the space
bar to continue.
8.
When the modification to the AppleWorks
PROGRAM Disk has been completed, the
program will prompt for a key press to quit. Press
the space bar and the modified AppleWorks can
then be booted in the normal manner.
Setting the AppleWorks Enhancement Options
Boot the AppleWorks startup disk just like you normally
would. (Notice that the AppleWorks version number
near the lower right corner of the startup screen now has
an "A" tagged onto its end (Ex: 2.0A). If it doesn't have an
"A: appended to the version number, it hasn't been
modified correctly.
When the startup disk has finished loading, remove the
startup disk and insert the program disk, but DO NOT
press return. Press
AppleWorks from a UniDisk 3.5 or a hard disk, press
when you are prompted with: "Press the Space Bar to
continue.
*
Note: It's not necessary to access the
options menu each time you boot
Started
AppleWorks. The
only used to set the enhanced AppleWorks
options.
instead. If you're booting
Getting Started
Chapter Eight
Getting
menu is
AW 2 Expander
-
47
Advertisement
Table of Contents
