Chapter 22 Multicast
22.3.1 IGMP Snooping
Click the IGMP Snooping link in the Advanced Application > Multicast > IPv4 Multicast
screen to display the screen as shown. See
multicasting.
Figure 110 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping
The following table describes the labels in this screen.
Table 84 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping
LABEL
IGMP Snooping
Active
Querier
Host Timeout
802.1p Priority
188
DESCRIPTION
Use these settings to configure IGMP snooping.
Select Active to enable IGMP Snooping to forward group multicast traffic only to ports
that are members of that group.
Select this option to allow the Switch to send IGMP General Query messages to the VLANs
with the multicast hosts attached.
Specify the time (from 1 to 16 711 450) in seconds that elapses before the Switch
removes an IGMP group membership entry if it does not receive report messages from
the port.
Select a priority level (0-7) to which the Switch changes the priority in outgoing IGMP
control packets. Otherwise, select No-Change to not replace the priority.
Section 22.1 on page 184
GS3700/XGS3700 Series User's Guide
for more information on