Electrolux EAW05E3AJW Instruction Manual page 31

59 electrolux solutions for problems
Problem Solution
Air conditioner cooling, but 1. Dirty air filter - air restricted. Clean air filter. Refer
room is too warm - NO ice to Care and Cleaning section.
forming on cooling coil 2. Temperature is set too high. Set temperature to a
behind decorative front. lower setting.
3. Air directional louvers positioned improperly.
Position louvers for better air distribution.
4. Front of unit is blocked by drapes, blinds,
furniture, etc. - restricts air distribution. Clear
blockage in front of unit.
5. Doors, windows, registers, etc. open - cool air
escapes. Close doors, windows, registers, etc.
6. Unit recently turned on in hot room. Allow
additional time to remove "stored heat" from walls,
ceiling, floor and furniture.
Air conditioner turns on 1. Dirty air filter - air restricted. Clean air filter.
and off rapidly. 2. Outside temperature extremely hot. Set FAN
speed to a faster setting to bring air through
cooling coils more frequently.
Noise when unit is cooling. 1. Air movement sound. This is normal. If too loud,
set to lower FAN setting.
2. Window vibration - poor installation. Refer to
installation instructions or check with installer.
Water dripping INSIDE 1. Improper installation. Tilt air conditioner slightly to
when unit is cooling. the outside to allow water drainage. Refer to
installation instructions or check with installer.
Water dripping OUTSIDE 1. Unit removing large quantity of moisture from
when unit is cooling. humid room. This is normal during excessively
humid days.
Problem Solution
Room too cold. 1. Set temperature too low. lncrease set
temperature.
2. Remote Sensing activated (on some models) and
remote control located in Hot Spot - Relocate
remote control or deactivate remote sensing.
1. If the display reads "AS" or "ES", a sensor has
Fault codes.
failed. Contact your Authorized Electrolux Service
Center.
solution for problems electrolux 60